iPhone 18 Series Protective Case | Installation and Removal Tutorial

UNIU iPhone 18 Series Cases | Installation and Removal Guide

The UNIU iPhone 18 series offers four different case designs and materials, and the removal methods vary slightly depending on the structural differences of each series.

This article compiles the correct installation and removal methods for the DOTTEX, NYLTEX, CRYLO, and DAPPER cases. Please follow the instructions for the specific model you are using.

DOTTEX Dot-Textured Impact Case

To enhance the snug fit and anti-slip effect between the case and the phone, the DOTTEX case features recessed corner coverage, making the corners feel tighter after installation.

Removal Method

It is recommended to start removing the case from the bottom two sides of the phone.

1. Gently push out one of the bottom corners until about half of the case separates from the phone.
2. Then, move to the other bottom side and loosen about half of it in the same manner.
3. Alternate between the left and right sides to gradually loosen all four corners.
4. Once the case gradually separates from the phone, you can easily remove the phone.

Friendly reminder:
Avoid pulling hard from a single corner. Alternating between left and right and loosening in stages will make it easier to remove.

DAPPER Matte Impact Case

The DAPPER case also features recessed corner coverage, allowing the case to fit more securely to the phone after installation, so the corners will feel tighter.

It is recommended to start removing the case from the bottom two sides of the phone.

1. Gently push out one of the bottom corners until about half of the case separates from the phone.
2. Then, move to the other bottom side and loosen about half of it in the same manner.
3. Alternate between the left and right sides to gradually loosen all four corners.
4. Once the case gradually separates from the phone, you can easily remove the phone.

Friendly reminder:
Avoid pulling hard from a single corner. Alternating between left and right and loosening in stages will make it easier to remove.

NYLTEX Woven Impact Case

The NYLTEX case can be removed by starting from one of the bottom sides of the phone.

Gently push out a bottom corner outwards, then sequentially loosen the other side and the surrounding edges, and you can then easily remove the phone from the case.

CRYLO Easy-Removal Clear Impact Case

The CRYLO case features a structural design that allows for easy daily installation and removal.

To remove, start from any corner on the bottom side of the phone, gently push the edge outwards. Once the bottom corner separates from the phone, you can easily remove the case.

Installation and Removal Precautions

When installing or removing the phone case, it is recommended to gradually separate the edges from the phone with your fingers. Do not use sharp tools to pry open the protective case, as this may scratch the phone or the case.